Harvey's Two Part Expoxy

[Irenicus]

I mounted some frags with this and as expected my skimmer when haywire, so much so that I had to unplug it. Any idea on how long it takes before I can plug in the skimmer again and expect it to run as it did prior to the epoxy use?

[Redwinger]

run carbon and do a couple large water changes. Usually lasts a day.

[Irenicus]

I don't have a device to run carbon yet but I will do some water changes.

Thanks Red!

[David Grigor]

If you have the ability, I usually keep the skimmer going to lower the water level as low as possible and restrict the air intake. About 24 hours later it pretty much back to normal and I put the levels back to normal positions.

I believe keeping the skimmer running helps remove whatever make the skimmer go nuts faster than just turning it off.......