Apex WXM for Vortech pumps?

Discussion in 'Equipment: Setup and Discussion' started by VikingsCrazy, Apr 14, 2019.

  1. VikingsCrazy

    VikingsCrazy TCMAS Event Committee
    Event Committee TCMAS Member TCMAS Supporter

    Joined:
    Aug 30, 2018
    Messages:
    590
    Likes Received:
    107
    Location:
    St Michael, MN, USA
    Do I need an WXM if I want to dial my Vectra M1 & L1 down at night, have the return shut down when feed is hit on Apex, and to get alerts if a pump is malfunctioning or has failed? I have a Vortech MP10W ecoSmart too. Will the WXM run this pump and/or future Vortech's the same way also? Sorry. I am dumb to all this technology install and set up stuff. Thanks
     
  2. ikserk

    ikserk Administrator
    Site Admin Lifetime Member

    Joined:
    Jun 9, 2013
    Messages:
    1,948
    Likes Received:
    376
    Location:
    New Hope, MN
    The wxm controls only vortech pumps and radion lights. The vectra pumps were never enabled on the Apex ecosystem.

    To control the vectra on a schedule you'll need the Ecotech Marine Reeflink.
     
  3. OP
    VikingsCrazy

    VikingsCrazy TCMAS Event Committee
    Event Committee TCMAS Member TCMAS Supporter

    Joined:
    Aug 30, 2018
    Messages:
    590
    Likes Received:
    107
    Location:
    St Michael, MN, USA
    Ok. Thank you! Sorry Ryan!
     

Share This Page