Nezw0001
Senior Member
BOD
Lifetime Member
Event Committee
TCMAS Member
TCMAS Supporter
Meeting Host 2020
OK Apex nerds, can someone help me figure out a way to fix things before I leave to Thailand?
Here is my situation. I have my ATO hooked up to saltwater so that replaces water as the skimmer removes it, hopefully its not much volume. My FW is on a timer that I adjust as needed with house humidity.
My skimmer pump is a red dragon that apparently can be controlled by the 0-10v apex output but I haven't been able to figure out an elegant solution to get the programming to work. Here are my asks
1. I would like to be able to shut off the skimmer if my ATO is running too much.
2. I would like to figure out how to use the 0-10v controllability to reduce the skimmer flow if the ATO is running too much.
this system works well as the only downside is if the skimmer overflows I might burn through a bunch of SW but at least I don't dump a ton of FW in. Any ideas all?
Here is my situation. I have my ATO hooked up to saltwater so that replaces water as the skimmer removes it, hopefully its not much volume. My FW is on a timer that I adjust as needed with house humidity.
My skimmer pump is a red dragon that apparently can be controlled by the 0-10v apex output but I haven't been able to figure out an elegant solution to get the programming to work. Here are my asks
1. I would like to be able to shut off the skimmer if my ATO is running too much.
2. I would like to figure out how to use the 0-10v controllability to reduce the skimmer flow if the ATO is running too much.
this system works well as the only downside is if the skimmer overflows I might burn through a bunch of SW but at least I don't dump a ton of FW in. Any ideas all?