OP
OP
little sandpaper to be sure burs don't mess up the lock fitting.[above]
Fritz's Home Display - Tank Build (1 Viewer)
- Thread starter REEFSTOCK
- Start date
OP
OP
I use silicone instead of pipe tape. Here I put on a hose fitting.
OP
OP
TADA Way better than the old gate valves for this application.
OP
OP
Finished all the lighting... most I need to put on the reflectors and decide where to put my moon vues.
OP
OP
OP
OP
3 ATI Blue Plus
2 Reef Brites
1 fiji purple
1 ATI Aqua Blue
1 ATI Coral Pluss (new bulb around 15k)
moonlights from Coral Vue yet to be added.
2 Reef Brites
1 fiji purple
1 ATI Aqua Blue
1 ATI Coral Pluss (new bulb around 15k)
moonlights from Coral Vue yet to be added.
OP
OP
OP
OP
See all those marks off the, To Do list!!!:banana:
OP
OP
New Manifold for reactors.
These go to 1/2" pipe for my BRS reactors.
These go to 1/2" pipe for my BRS reactors.
Last edited:
OP
OP
Did I mention silicon for threaded connections?
OP
OP
One thing I am going to have to fix. I found that the water finds it easier to flow into my tank above then the reactors below. I will need to put a Loc Line valve up in the aquarium to provide back pressure for the reactors. 
:lookaround:
:lookaround:
OP
OP
Bottom is DONE!
see the buble wand light in the back? Perfect for Sump time. Its now on a switch. hmm I am missing a picture of the switch it seems.
Also the tubes go to the filter sock. I prefer that in case carbon or gfo gets hicuped out.
see the buble wand light in the back? Perfect for Sump time. Its now on a switch. hmm I am missing a picture of the switch it seems.
Also the tubes go to the filter sock. I prefer that in case carbon or gfo gets hicuped out.
OP
OP
I found the perfect mount for BRS reactors!
OP
OP
Tunze Osmolator: Be sure to set the jumper in the "Turn off after 10 minutes of continual use" Position. IT IS NOT stock that way.
OP
OP
Here is another thing Dan turned me on to. Drill a hole in these electrical cord plastic clams. I cleaned up all the electrical. I can't believe how clean it looks up there!!!
OP
OP
Bottom is DONE!
see the buble wand light in the back? Perfect for Sump time. Its now on a switch. hmm I am missing a picture of the switch it seems.
Also the tubes go to the filter sock. I prefer that in case carbon or gfo gets hicuped out.
Awesome plumbing setup. Very clean :fritz:
Nice sump Fritz!! Any other (wider) shots? I'm re-doing some of the plumbing and I'm in love with your sump plumbing
OP
OP
That is the whole sump. What part would you like me to shoot? I could try a lower shot?
Very nice! Tried cleaning up my electrical, but looks nothing like yours